NOVABLAST CHEMICAL BREAKER.PH-09343778229
NOVATECH INDIA.PH-09343778229
NOVABLAST
Non explosive demolition powder Uses
NOVABLAST Chemical Breaker has been designed for demolition of concrete, rock and boulders in environmentally sensitive areas where vibration must be minimized. It is also suitable for controlled splitting of concrete, rock, boulders and quarrying of natural stone that will be accomplished smoothly and efficiently with superior yield in shorter time.
Advantages
„ Safe: Can be used by personnel without explosive training.
„ Simple : Requires only mixing with recommended quantity of water to activate
„ Quiet : No explosive sounds or vibration.
„ Controlled : Eliminates hazard of flying rock.
„ Versatile : Range of grades available to meet all application requirements.
Description
NOVABLAST Chemical Breaker is a special blend of cements and
additives to provide a sustained expansion after setting. This
expansion creates the fragmentation.
Three grades are available for use in temperatures.
10 – 20 degree Type A
20 – 35 degree Type B
35 – 50 degree Type C
Technical Support
An experienced technical advisory team is available to give
technical service on request.
Properties
Expansion :
Expansion forces more than 30 N/mm2 are typically achieved in a period of 18 – 24 hours. This acts against the tensile strength of the material to be fragmented.
Application instructions
Preparation
A pattern of holes should be established, bearing in mind
need to create a free face. Typically, the hole spacing will be
about 10 times the hole diameter. The spacing chosen will
depend upon the degree of fragmentation desired. The holes
should preferably be greater than 25mm dia and 500mm length
Do not use in holes greater than 50mm diameter. For greater
hole diameter consult NOVATECH INDIA
Application
The recommended water powder ratio is 0.25 to 0.30 for all grades that is 1.5 liters for 5 kg packet
Us i n g Ta b l e 1 t h e q u a n t i t y o f powder needed c a n b e
Calculated based on diameter, length and total number of
holes. A measured quantity of water should be placed in a
mixing drum. Water should not exceed 1.5litres per 5kg of
NOVABLAST Chemical Breaker.
The powder should be added to the water, being continuously
stirred with a hand mixer or drill and paddle until a lump free,
even consistency is obtained.
The mixed material will become a light gel within a maximum
of 15 minutes from mixing. For ease of placing the grout
should be poured into the holes before this time has elapsed.
Care must be taken to ensure that the grout level is flush with
the mouth of the hole. Cover the mouth of the hole by sacking
or sheeting directly after filling, and then retire immediately.
After placing, Chemical Breaker should be left undisturbed
until full cracking has taken place up to 24 hours after pouring.
It is recommended that the work area is cordoned off with
warning signs.
Estimating Storage
12 months in unopened pack if stored in dry environment.
Op e n e d p a c k s s h o u l d b e t i g h t l y r e s e a l e d , k e p t i n d r y
conditions and used within 1 month of opening.
Packaging
• NOVABLAST Chemical Breaker is supplied in 5KG packets of 4 packets in a bag or box totaling 20 kegs’
NOVABLAST
Non explosive demolition powder Uses
NOVABLAST Chemical Breaker has been designed for demolition of concrete, rock and boulders in environmentally sensitive areas where vibration must be minimized. It is also suitable for controlled splitting of concrete, rock, boulders and quarrying of natural stone that will be accomplished smoothly and efficiently with superior yield in shorter time.
Advantages
„ Safe: Can be used by personnel without explosive training.
„ Simple : Requires only mixing with recommended quantity of water to activate
„ Quiet : No explosive sounds or vibration.
„ Controlled : Eliminates hazard of flying rock.
„ Versatile : Range of grades available to meet all application requirements.
Description
NOVABLAST Chemical Breaker is a special blend of cements and
additives to provide a sustained expansion after setting. This
expansion creates the fragmentation.
Three grades are available for use in temperatures.
10 – 20 degree Type A
20 – 35 degree Type B
35 – 50 degree Type C
Technical Support
An experienced technical advisory team is available to give
technical service on request.
Properties
Expansion :
Expansion forces more than 30 N/mm2 are typically achieved in a period of 18 – 24 hours. This acts against the tensile strength of the material to be fragmented.
Application instructions
Preparation
A pattern of holes should be established, bearing in mind
need to create a free face. Typically, the hole spacing will be
about 10 times the hole diameter. The spacing chosen will
depend upon the degree of fragmentation desired. The holes
should preferably be greater than 25mm dia and 500mm length
Do not use in holes greater than 50mm diameter. For greater
hole diameter consult NOVATECH INDIA
Application
The recommended water powder ratio is 0.25 to 0.30 for all grades that is 1.5 liters for 5 kg packet
Us i n g Ta b l e 1 t h e q u a n t i t y o f powder needed c a n b e
Calculated based on diameter, length and total number of
holes. A measured quantity of water should be placed in a
mixing drum. Water should not exceed 1.5litres per 5kg of
NOVABLAST Chemical Breaker.
The powder should be added to the water, being continuously
stirred with a hand mixer or drill and paddle until a lump free,
even consistency is obtained.
The mixed material will become a light gel within a maximum
of 15 minutes from mixing. For ease of placing the grout
should be poured into the holes before this time has elapsed.
Care must be taken to ensure that the grout level is flush with
the mouth of the hole. Cover the mouth of the hole by sacking
or sheeting directly after filling, and then retire immediately.
After placing, Chemical Breaker should be left undisturbed
until full cracking has taken place up to 24 hours after pouring.
It is recommended that the work area is cordoned off with
warning signs.
Estimating Storage
12 months in unopened pack if stored in dry environment.
Op e n e d p a c k s s h o u l d b e t i g h t l y r e s e a l e d , k e p t i n d r y
conditions and used within 1 month of opening.
Packaging
• NOVABLAST Chemical Breaker is supplied in 5KG packets of 4 packets in a bag or box totaling 20 kegs’
Contact Detail
Company Name :NOVATECH INDIA
Contact Person
: CHRISTOPHER JAMES
Designation : MANAGING PARTNER
Office Address :8.C,THIRD FLOOR,
NITHIN ARCADE,
RAMAMURTHY NAGAR SIGNAL ROAD,
DODDA BANASAWDI,BANGALORE-560 043.
080-60606099
09243001100
09343778229
|
Company Profile
|
|
Soundless Rock Breaking
Chemicals, Chemical Breaker, Silent Rock Cracking Mortar, Silent Cracking
Agent, Concrete Cracking Chemical, Concrete Dismantling Chemicals, Soundless
Rock Cracking Chemicals, Blasting Chemicals, Rock Breaking Chemicals,
Residential Demolition, Water Blasting Chemicals, Water Blasting Additives,
Stone Blasting Chemicals, Rock Blasting Chemicals, Home Demolition Services,
Building Demolition Contractors, High Performance Rock Cracking Agent, Rock
Cracking Agent, Soundless Rock Cracking Mortar, Rock Breaking Mortar, Silent
Breaking Agent, Silent Cracking Chemicals, Concrete Demolition Chemicals,
Demolition Chemicals, Concrete Cracking Mortar, Concrete Breaking Mortar,
Concrete Cracking Compound, Silent Concrete Breaking Chemical, Safety Belts,
Safety Nets, Solar Panels, Ups, Battery For Ups, Inverters, Power Motors, Solar
Power Systems, Silent Demolition
Agent, Silent Rock Dismantlers, Silent Blasting Mortar
Rock excavation by not using any
explosive, Rock removal by not using any explosives, Rock blasting by not using
any explosives
Thanks for sharing the information.
ReplyDeleteExpando is the ideal alternative to noisy, risky concrete and rock breaking solutions like explosive blasting, jack hammering, concrete saws and stone cutters particularly on sites with noise restrictions.Non Explosive Demolition Agent